Digisol DG-CS4616F 설치 매뉴얼 - 페이지 7

{카테고리_이름} Digisol DG-CS4616F에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digisol DG-CS4616F 17 페이지. Giga layer 3 switch

Chapter 2 Hardware Installation

To ensure the proper operation of DG-CS4616F and your physical security, please

read carefully the following installation guide.

The switch must be installed in a clean area. Otherwise, the switch may be damaged



by electrostatic adherence.

Maintain the temperature within 0 to 50 °C and the humidity within 5% to 95%,



non-condensing.

The switch must be put in a dry and cool place. Leave sufficient spacing around the



switch for good air circulation.

The switch must work in the right range of power input (AC power: 100~



(

), DC power: -48~-60VDC, 2.5A)

50/60 Hz

The switch must be well grounded in order to avoid ESD damage and physical injury



of people.

The switch should avoid the sunlight perpendicular incidence. Keep the switch away



from heat sources and strong electromagnetic interference sources.

The switch must be mounted to a standard 19'' rack or placed on a clean level



desktop.

2.1.1.1 Dust and Particles

Dust is harmful to the safe operation of DG-CS4616F. Dust can lead to electrostatic

adherence, especially likely under low relative humidity, causing poor contact of metal

connectors or contacts. Electrostatic adherence will result in not only reduced product

lifespan, but also increased chance of communication failures. The recommended value

for dust content and particle diameter in the site is shown below:

Max Diameter (µm)

Max Density

(particles/m³)

0.5

1.4×10

7×10

Chapter 2-1

DG-CS4616F Installation Guide

240VAC, 1.0A

2.4×10

1.3×10