Digisol DG-GS4200 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Digisol DG-GS4200 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digisol DG-GS4200 Series 19 페이지. Giga layer 2 switches

Chapter 2 Hardware Installation

To ensure the proper operation of DG-GS4200 series and your physical security,

please read carefully the following installation guide.



The switch must be installed in a clean area. Otherwise, the switch may be damaged

by electrostatic adherence.



Maintain the temperature and the humidity within the set environment.



The switch must be put in a dry and cool place. Leave sufficient spacing around the

switch for good air circulation.



The switch must work in the right range of power input.



The switch must be well grounded in order to avoid ESD damage and physical injury

of people.



The switch should avoid the sunlight perpendicular incidence. Keep the switch away

from heat sources and strong electromagnetic interference sources.



The switch must be mounted to a standard 19'' rack or placed on a clean level

desktop.

2.1.1.1 Dust and Particles

Dust is harmful to the safe operation of switch. Dust can lead to electrostatic

adherence, especially likely under low relative humidity, causing poor contact of metal

connectors or contacts. Electrostatic adherence will result in not only reduced product

lifespan, but also increased chance of communication failures. The recommended value

for dust content and particle diameter in the site is shown below:

Max Diameter (µm)

Max Density

(particles/m³)

Table 2-1 Environmental Requirements: Dust content

0.5

1.4×10

7×10

2-1

DG-GS4200 Installation Guide

2.4×10

1.3×10