Digisol DG-GS4526P 설치 매뉴얼 - 페이지 16

{카테고리_이름} Digisol DG-GS4526P에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digisol DG-GS4526P 18 페이지. 22 port 10/100/1000mbps layer 2 poe switch with 4 gc ports

Digisol DG-GS4526P 설치 매뉴얼
2.
Connect the other side of the console cable to a character terminal (PC).
3.
Power on the switch and the character terminal. Configure the switch through the
character terminal.

2.3.3 SFP Transceiver Installation

DG-GS4526Pseries provide multiple 1000Mb SFP transceiver slots.
The procedure for installing the SFP transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves)
Step 2: Insert the SFP transceiver to the guide rail inside the fiber interface line card. Do
not put the SFP transceiver up-side-down.
Step 3: Push the SFP transceiver along the guide rail gently until you feel the transceiver
snap into place at the bottom of the line card.
Note: the SFP transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bore in the SFP transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.

2.3.4 Copper Cable/Fiber Cable Connection

Copper cables should be connected as below:
Step 1:
Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch
copper cable line card;
Step 2:
Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some
other device;
Step 3:
Check all status indicators for the corresponding ports; a lighted LED indicates
that the link has been established, otherwise the link is not ready and the cable should be
examined.
Caution!
Please verify the sign above the port to ensure using the right port. Connecting to wrong
ports might damage the switch.
DG-GS4526P Installation Guide
16