FIBARO Wall Plug 짧은 서비스 매뉴얼 - 페이지 2

{카테고리_이름} FIBARO Wall Plug에 대한 짧은 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO Wall Plug 3 페이지. Fgwpe/f-101 v.2.1 - v.2.3
FIBARO Wall Plug에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지)

페이지 인쇄

First step to provide professional support and service is proper diagnose of failure. To avoid sending

fully functional devices to warranty service, please follow step by step guide below.

STEP 1. Check visually.

FIBARO Wall Plug should have no scratches or cracks visible. However, if there are any heavy

mechanical damages, as smashed casing, casing bitten by a dog, warranty will not be

considered!

STEP 2. Resetting FIBARO Wall Plug.

The FIBARO Wall Plug reset erases the EEPROM memory, including all information on the Z-

Wave network and the main controller.

Reset procedure:

-insert the Plug into socket;

-press and hold the B-button for few seconds until the LED turns yellow;

-release the B-button;

-again press the B-button briefly.

Successful reset will be confirmed with the LED changing color to red. If after pressing B

button nothing happens, it may prove broken B button.

STEP 3. Excluding and including sensor from Z-Wave Network.

Before every inclusion, Plug must be excluded from Z-Wave network. This can be done in

two ways, resetting Plug or:

-insert the Plug into socket;

-set main controller in learn mode (delete device mode);

-press B-button three times briefly;

-after procedure in main controller ends, unplug device from the socket;

-plug device in the socket again, LED should turn red.

To include Plug into Z-Wave network, please follow:

-set main controller in learn mode (add device mode);

-press B-button three times briefly;

-Plug should be added to device panel. Press B-button three times briefly to wake it up;

-test the Plug's operation – check whether the LED diode indicates change in relay output,

connect some device (laptop, electric kettle) to check whether the relay is working properly.