FIBARO FIB_FGSS-101 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} FIBARO FIB_FGSS-101에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FIB_FGSS-101 15 페이지. Smoke detector

Switching to a constant current powering mode:

1. Exclude a sensor from the Z-Wave network.

2. Disconnect the battery.

3. Install the constant power connecting terminal, observing the diagram 2.

4. Connect a constant current power source (12 / 24 VDC) to +12 and GND terminals observing wiring

diagram 1.

5. Include Fibaro Smoke Sensor into the Z-Wave network.

Installation:

1. Include the device into the Z-Wave network (see p.I). Note the inclusion process may be performed

ONLY in direct range of the main controller.

2. If the sensor is to be VDC powered, drill holes in sensor's holder. Note the sensor may be connected

to a wired alarm system controller or fire prevention system.

3. Install the sensor's holder in desired location.

4. If the sensor is to be VDC powered, connect wires observing diagram 3.

5. If the sensor is to be connected to an alarm system or fire prevention system, connect it observing to

diagram 4.