FIBARO FGDW-002 운영 매뉴얼 - 페이지 7

{카테고리_이름} FIBARO FGDW-002에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGDW-002 16 페이지. Door/window sensor
FIBARO FGDW-002에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

#5: Operating the device

Tamper (TMP) button:

The Door/Window Sensor 2 is equipped with a tamper switch with

two buttons.

First TMP button is located inside the device, pressed by the closed

cover and is used to detect openning it.

Second TMP button is located at bottom of the device, pressed by the

surface on which the device is mounted and is used to detect detach-

ing the device.

For the tamper switch to work one of the buttons must always be

pressed!

When one of the buttons is released, the tamper alarm will be send to

the controller and associated devices.

Additionally, tamper button allows to control the device directly.

TMP

button

Controlling the Door/Window Sensor 2 with FIBARO Home Center

controller:

After adding the Sensor to the FIBARO System, it will be represented

by two or three icons in Home Center interface.

First icon informs about the status of magnetic sensor (open/close),

second icon displays temperature measured by the built-in sensor.

Third icon is assigned to high/low temperature alarm and is visible only

if parameter 54 is not equal to 0.

Waking up the Door/Window Sensor 2:

The Door/Window Sensor 2 needs to be woken up to receive informa-

tion about the new configuration from the controller, like parameters

and associations.

To wake up the sensor manually, click one of the TMP buttons (while

the other button is pressed).

OPERATInG THE DEVICE