Crestron 4K DigitalMedia DMPS3-4K-150-C 보충 설명서 - 페이지 8
{카테고리_이름} Crestron 4K DigitalMedia DMPS3-4K-150-C에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron 4K DigitalMedia DMPS3-4K-150-C 20 페이지. 3-series digitalmedia presentation system 150
Crestron 4K DigitalMedia DMPS3-4K-150-C에 대해서도 마찬가지입니다: 매뉴얼에서 (2 페이지), 매뉴얼 (2 페이지), 매뉴얼에서 (2 페이지)
페이지 인쇄
DM IN 1-2: 8-pin RJ-45 female, shielded;
DM 8G+
PoDM PSE (Power Sourcing Equipment) ports
Each connects to the DM 8G+ output of a DigitalMedia transmitter or other DM device
or to an HDBaseT device via CAT5e, Crestron DM-CBL-8G, or Crestron
DM-CBL-ULTRA cable;
Green LED indicates DM link status;
Solid amber LED indicates HDCP video;
Blinking amber LED indicates non-HDCP video
NOTE:
intrabuilding use only and should not be connected to a line that runs outside of the
building in which the PSE is located.
HDMI OUT: 19-pin Type A HDMI female;
Digital video/audio output;
Signal Types: HDMI, DVI
NOTE:
accommodate a DVI signal or Dual-Mode DisplayPort signal. The CBL-HD-DVI interface
cable is sold separately.
DM OUT: 8-pin RJ-45 female, shielded;
DM 8G+ output, HDBaseT standard compliant;
PoDM PSE (Power Sourcing Equipment) port
Connects to the DM 8G+ input of a DigitalMedia receiver or other DM device or to an
HDBaseT device via CAT5e, Crestron DM-CBL-8G, or Crestron DM-CBL-ULTRA cable;
Green LED indicates DM link status;
Solid amber LED indicates HDCP video;
Blinking amber LED indicates non-HDCP video
RELAY 1-2: 4-pin 3.5 mm detachable terminal block;
Comprises 2 normally open, isolated relays;
Rated 1 Amp, 30 volts ac/dc;
MOV arc suppression across contacts
INPUT 1-2: 3-pin 3.5 mm detachable terminal block;
Comprises 2 programmable digital inputs;
Input Voltage Range: 0 to 24 Vdc, referenced to GND;
Logic Threshold: 2.5 Vdc nominal with 1 Volt hysteresis band;
Input Impedance: 10k Ohms at >5 volts, 1M Ohms at <5 volts;
Pull-up Resistor: 2.2k Ohms per input
MIC IN: 3-pin 3.5 mm detachable terminal block;
Balanced microphone audio input;
Input Level: -60 to 0 dBV, 1 Vrms maximum;
Input Impedance: 6.5k Ohms balanced;
Phantom Power: 48 Vdc, software enabled/disabled
LAN: 8-pin RJ45 female;
10BASE-T/100BASE-TX Ethernet port
Ground (
100-240 V~1.4 A 50/60 Hz: IEC 60320 C14 mains power inlet;
Mates with removable power cord, included
4 • DMPS3-4K-150-C: 3-Series 4K DigitalMedia Presentation System
inputs, HDBaseT
standard compliant;
®
®
Any wiring that is connected to a PoDM or HDBaseT PoE PSE port is for
The HDMI output requires an appropriate adapter or interface cable to
): 6-32 screw, chassis ground lug
HDBaseT PoE compatible);
(
HDBaseT PoE compatible);
(
Supplemental Guide – DOC. 7724A