FIBARO FGMS-001 운영 매뉴얼 - 페이지 11

{카테고리_이름} FIBARO FGMS-001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGMS-001 20 페이지. Motion sensor
FIBARO FGMS-001에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (11 페이지)

페이지 인쇄

#8: Advanced parameters

The Motion Sensor allows to customize its operation to user's needs.

The settings are available in the FIBARO interface as simple options

that may be chosen by selecting the appropriate box.

In order to configure the Motion Sensor (using the home Center con-

troller):

1. Go to the device options by clicking the icon:

2. Select the „Advanced" tab.

Wake up interval

Available settings: 1-65535 (1-65535 seconds)

Default setting: 7200 (every 2 hours)

The Motion Sensor will wake up after each defined time interval and

always try to connect with the main controller. After a successful com-

munication attempt, the sensor will update configuration parame-

ters, associations and settings and will go into standby mode. After

failed communication attempt (e.g. lack of Z-Wave range) the device

will go into standby mode and retry to establish connection with the

main controller after the next time interval.

Wake up may be performed manually by a single B-button click.

Longer time interval means less frequent communication and thus a

longer battery life.

1. Motion detection - sensitivity

The lower the value, the more sensitive the PIR sensor is.

Available settings: 8-255

Default setting:

2. Motion detection - blind time

PIR sensor is "blind" (insensitive) to motion after last detection for the

amount of time specified in this parameter.

Shorter time periods allow to detect motion more frequently, but the

battery will be drained faster.

Available settings: 0-15 (0.5-8 seconds, time [s] = 0.5 x (value+1))

Default setting:

Parameter size:

2 [bytes]

1 [byte]

ADvAnCED PARAMETERS

NOTE

Blind time should be

shorter that the time

period set in parame-

ter 6 (alarm cancella-

tion delay).