ACTOR-MATE Rock Star AL12-05R 사용자 설명서 - 페이지 2

{카테고리_이름} ACTOR-MATE Rock Star AL12-05R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACTOR-MATE Rock Star AL12-05R 4 페이지. Rock star al12 series dmx laser

페이지 인쇄

Trouble Shooting

If there is no light from the unit, please check the main power supply and fuse.

If unit does not respond to DMX, please check the DMX cables are connected

properly and are wired correctly.

If unit does not response to the music please adjust the sound-active sensitivity level

by Sensitivity Adjustment Knob.

If problems cannot be solved please contact your dealer for service

Fuse Replacement

Always disconnect from main power supply before attempting to replace the fuse

Remove the old fuse from the holder and replace with the exact same type fuse.

Replacement with anything other than the specified part may damage your unit.

Cleaning

Use a soft cloth and normal glass cleaner to clean the outside casing. Cleaning

frequency depends on the environment in which the fixture operates. Be sure to dry

all parts before plugging the unit back in.

Operating Modes

1. Stand-Alone Operation (Sound Active Mode)

Sound Active mode

This unit has built-in program that will react to sound and music under Sound

Active mode. Set all DIP switch pins to OFF to run Sound Active mode

2. DMX Operation

DMX operation gives the users freedom to create their own programs tailored to

their own individual needs.

To run this unit in DMX mode, connect the unit to any standard DMX controller

via XLR connectors.

Please consult DMX controller manual to determine address.

DMX Signal Levels

Channel 1

Laser pattern and effect

Movement speed control.

controls

Channel-2 is functional only

when value at channel-1 is

set between 100 and 189.

Value

Effect

Value

0-1

OFF

0-42

2-99

49 patterns

43-85

100-189

45 animations

86-128

190-255

Sound Active

129-171

172-214

215-255

Function Selection Chart

DIP SWITCHES CHART

OFF OFF OFF OFF OFF OFF OFF OFF OFF

SET ADDRESS

Channel 2

Channel 3

Line effect control. User

can change the patterns

to dot-line patterns by

control this channel.

Speed

e.g.

FAST

SLOW

FUNCTION

SOUND MODE

DMX MODE