DigiSport DT500 사용 설명서 - 페이지 4

{카테고리_이름} DigiSport DT500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiSport DT500 10 페이지. Pro-stopwatches

PRINT MODE:

1. Press C button to go to the PRINT ALL mode as shown in Fig.20.

2. Pressing A button will print all recorded memories to the printer (if printer is connected). When the stopwatch is in the process of

printing, an indicator moves from right to left. When printing is complete PRINT END is displayed.

3. Pressing B at the PRINT ALL mode will go to the PRINT RACE mode with display as shown in Fig.21.

4. Pressing A in this mode will only print the memories in this race.

5. Press B to select particular race to print.

6. Pressing C any time during this printing process will stop printing immediately.

7. If the chronograph is not reset (i.e. still running or stopped), it will not be possible to upload and the display will show PRINT 0,

there will not be any action upon pressing A or B.

CARE OF YOUR STOPWATCH:

WATER-RESISTANCE

The stopwatch is designed to withstand accidental contact with water such as splashes or rain, but it, is not designed for use in

water. Do not operate the buttons when the stopwatch is wet.

TEMPERATURE

Do not leave your stopwatch under direct sunlight or in very high temperatures for a long time, or the display may become black. Do

not leave your stopwatch in very low temperature as this may cause a slight time loss or gain and the change of digits becomes slow.

In both cases the above conditions will be corrected when the stopwatch returns to normal temperature.

SHOCKS

Be careful not to drop your stopwatch or hit it against hard surfaces as it may cause mechanical damages.

STATIC ELECTRICITY

The integrated circuit in your stopwatch can be affected by static electricity. If the static electricity is very strong a permanent damage

can occur.

MAGNETISM

Not affected.

CHEMICALS

Do not expose your stopwatch to solvents such as gasoline and alcohol, spray of cosmetics, cleaners, paints etc as they may cause

damage to the stopwatch.

When the battery low indicator lights up, battery replacement is necessary.

1. Unscrew and remove the back cover.

2. Unscrew the battery contact.

3. Replace with fresh Lithium battery CR2032 or equivalent.

4. Before putting in the fresh battery makes sure that the triangular contact is in the triangular slot under the battery.

5. Use a small metal tool (such as a tweezers or screw driver) to momentarily short circuit the AC pad next to the battery.

6. Re-screw the back cover.

Trouble shooting

If the stopwatch is out of service, such as wrong logic, frozen display etc., a reset may recover the stopwatch. To reset the

stopwatch, please press all four buttons simultaneously for about 2 seconds until the display become blank, the stopwatch will return

to the default state when you release the buttons.

THE WARRANTY DOES NOT COVER THE BATTERY.