Sharp Carousel R-395NS 서비스 매뉴얼 - 페이지 23

{카테고리_이름} Sharp Carousel R-395NS에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Carousel R-395NS 28 페이지. Microwave oven
Sharp Carousel R-395NS에 대해서도 마찬가지입니다: 운영 매뉴얼 및 쿡북 (40 페이지)

페이지 인쇄

2) An approved microwave survey meter should be used to assure

compliance with proper microwave radiation emission limitation

standards.

3. After any service, make sure of the following:

1. Door latch heads smoothly catch latch hook through latch holes

and that latch head goes through center of latch hole.

2. Deviation of door alignment from horizontal line of cavity face plate

is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity face plate.

4. Check for microwave leakage around door with an approved micro-

wave survey meter. (Refer to Microwave Measurement Procedure.)

NOTE: The door on a microwave oven is designed to act as an

electronic seal preventing the leakage of microwave

energy from oven cavity during cook cycle. This function

does not require that door be air-tight, moisture (conden-

sation)-tight or light-tight. Therefore, occasional appear-

ance of moisture, light or sensing of gentle warm air

movement around oven door is not abnormal and do not

of themselves, indicate a leakage of microwave energy

from oven cavity.

Upper Oven

Upper

Hinge

Oven Hinge

Slit choke of

door panel

Lower Oven

Hinge

Figure C-7. Door Replacement

Lower

Oven Hinge

Choke Cover

4. SEALER FILM

1. Put the adhesive tape on the backing film of the sealer film as

shown in Fig. C-7

2. Tear the backing film by pulling the adhesive tape.

3. Put the pasted side of the sealer film on the door panel

Sealer film

11 – 6

R395N(S)

Backing film

Adhesive tape

Figure C-7. Sealer film