Sharp Aquos 운영 매뉴얼 - 페이지 18

{카테고리_이름} Sharp Aquos에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Aquos 41 페이지. Led backlight tv / monitor
Sharp Aquos에 대해서도 마찬가지입니다: 사용자 설명서 (30 페이지), 운영 매뉴얼 (35 페이지), 운영 매뉴얼 (37 페이지)

페이지 인쇄

Settings

General Settings (Continue)

Input/Output

Consumer Electronic Control (CEC)

Change the label for an input terminal, and switch between HDMI CEC

Control Settings.

HDMI Type Selection

Sets the HDMI type for HDMI IN 1 and 2 terminals.

Set to "Full" when an HDMI 4K60P 4:4:4 device is connected, and set to

"Limited" when an HDMI 4:2:0 device is connected.

NOTE

When HDR video (HDMI 4K60P 4:4:4 signal) does not appear, please set

"HDMI Type Selection" to "Full".

Audio Out

Allows you to select what controls the audio output.

Variable: Sound via the AUDIO OUT terminal is adjusted with VOL+/- on

the remote control unit or on the TV.

When connected to the terminal, Sound via speaker is muted.

Fixed: Sound via speaker is adjusted with VOL+/- on the remote control unit

or on the TV.

Sound via the AUDIO OUT terminal is not adjustable and outputs at a

consistent level.

Audio Select HDMI

This function sets the terminal to output the computer audio.

The adjustment items vary depending on the input source. Select the input

source corresponding to the terminal connected to the PC and then adjust the

desired item.

To perform the operation, refer to "HOME" > "Settings" > "Input/Output" >

"Audio Select HDMI".

HDMI 2

HDMI: Select this when the TV and PC are connected using an HDMI-

certified cable and audio is input via the same cable.

HDMI + AV Input: Select this when the TV and PC are connected using a

HDMI-certified cable and the audio is input via a Ø 3.5 mm stereo

minijack.

NOTE

When "Audio Select HDMI " is set to "HDMI + AV Input", sound will not be

produced if you use only an HDMI-certified cable to connect HDMI-

compatible equipment. To produce sound, you should make an analogue

audio connection.

If you want to connect HDMI-compatible equipment using only an HDMI-

certified cable, set "Audio Select HDMI" to "HDMI".

"Audio Select HDMI" can only be set for the HDMI IN 2.

HDMI3 and HDMI4 support 8K signals.

The center and lower USB terminals support 8K video playback. In

addition, 5V/1.5A power can be supplied.

The upper USB terminal can supply 5V/0.5A power. Also, 8K video

playback is not supported.

EN 4-3