Sharp Aquos LC 37D64U 운영 매뉴얼 - 페이지 23
{카테고리_이름} Sharp Aquos LC 37D64U에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Aquos LC 37D64U 44 페이지. Sharp aquos lc-19sb25u: user guide
Sharp Aquos LC 37D64U에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지)
페이지 인쇄
On-Screen Display Menu
Power Control Menu
Power control setting allows you to save energy.
Example
Power Control
No Signal Off
No Operation Off
1
Press MENU to display the MENU screen, and then
press c/d to select "Power Control".
2
Press a/b to select a "No Signal Off" or "No
Operation Off", and then press ENTER.
3
Press c/d to select "Enable", and then press
ENTER.
4
Press MENU to exit.
No Signal Off
When set to"Enable", the power will automatically shut
down if there is no signal for 15 minutes.
•
Five minutes before the power shuts down, the remaining
time displays every minute.
•
"Disable" is the factory preset value.
•
When a TV program fi nishes, this function may not operate.
No Operation Off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
•
Five minutes before the power shuts down, the remaining
time displays every minute.
•
"Disable" is the factory preset value.
[Disable]
[Disable]
Setup Menu
Example
Setup
EZ Setup
CH Setup
Antenna Setup-DIGITAL
Input Skip
Parental CTRL
Position
Language
Reset
1
Press MENU to display the MENU screen, and then
press c/d to select "Setup".
2
Press a/b to select a specifi c adjustment item,
and then press ENTER.
•
When you select "EZ Setup", "CH Setup", "Parental
CTRL" or "Reset", you can enter the 4-digit secret
number here. See page 23 for setting a secret number.
3
Press a/b (or c/d) to select the desired setting,
and then press ENTER.
4
Press MENU to exit.
EZ Setup
You can run EZ Setup again, even after setting up the
preset channels.
Language: Select from among 3 languages (English,
French and Spanish).
TV Location: Select "Home" or "Store" for the location
where you plan to install the TV.
•
If you select "Home", AV MODE is set to "STANDARD".
•
If you select "Store", AV MODE is set to "DYNAMIC (Fixed)".
In case no remote control signal is received within 30
minutes, AV MODE will change to "DYNAMIC (Fixed)"
automatically.
Air/Cable: Make sure what kind of connection is made
with your TV when selecting "Air" or "Cable".
CH Search: Channel auto search makes the TV look for
all channels viewable in the set area.
•
See "Initial Setup" on page 12 for setting each item.
•
If no channel is found, confi rm the type of connection made
with your TV and try EZ Setup again.
•
If you select "Analog Search Start" and initiate the channel
search, the CH Memory for Cable Digital will be deleted.
[English]
21