Sharp Aquos LC-32LE600S 운영 매뉴얼 - 페이지 27
{카테고리_이름} Sharp Aquos LC-32LE600S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Aquos LC-32LE600S 36 페이지. Téléviseur couleur à écran
Sharp Aquos LC-32LE600S에 대해서도 마찬가지입니다: 운영 매뉴얼 (5 페이지), (스페인어) 매뉴얼 델 유저리오 (36 페이지), (프랑스어) Mode D'emploi (36 페이지)
페이지 인쇄
Connecting a PC
Connecting a PC
HDMI Connection
PC
HDMI-certified cable
PC
DVI/HDMI cable
*
When using the HDMI 2 terminal, you must select the proper
item in the "PC Audio Select" menu depending on the type of
HDMI cable connected (Refer to page 19 for details).
Analogue Connection
PC
RGB cable
PC
DVI/RGB conversion
cable
*
When using the EXT 4 terminal, you must select "EXT 4 (RGB)"
in the "PC Audio Select" menu (Refer to page 19 for details).
NOTE
•
The PC input terminals are DDC1/2B-compatible.
•
Refer to page 27 for a list of PC signals compatible with the TV.
•
When connecting to a PC, the input signal type is automatically
detected.
HDMI 1, 2 or 3
HDMI 2*
ø 3.5 mm stereo
minijack cable
EXT 4*
ø 3.5 mm stereo
minijack cable
EXT 4*
ø 3.5 mm stereo
minijack cable
Adjusting the PC image
automatically
This function enables the screen to be automatically
adjusted to its best possible condition when the analogue
terminals of the TV and PC are connected with a
commercially available DVI/RGB conversion cable, etc.
Setup
Auto Sync.
NOTE
•
"Auto Sync." may fail if the PC image has low resolution, has
unclear (black) edges, or is moved while executing "Auto
Sync.".
•
Be sure to connect the PC to the TV and switch it on before
starting "Auto Sync.".
•
"Auto Sync." can be executed only when inputting analogue
signals through the EXT 4 terminal.
Adjusting the PC image manually
Ordinarily you can easily adjust the picture as necessary
to change image position using "Auto Sync.". In some
cases, however, manual adjustment is needed to
optimise the image.
Setup
Fine Sync.
Press a/b to select the specific adjustment
1
item.
Press c/d to adjust the item to the desired
2
position.
H-Pos.
V-Pos.
Clock
Phase
Centres the image by moving it to the
H-Pos.
left or right.
Centres the image by moving it up or
V-Pos.
down.
Adjusts when the image flickers with
Clock
vertical stripes.
Adjusts when characters have low
Phase
contrast or when the image flickers.
NOTE
•
For resetting all adjustment items to the factory preset values,
press a/b to select "Reset", and then press ;.
•
"Clock" and "Phase" in the "Fine Sync." menu can be adjusted
only when inputting analogue signals through the EXT 4
terminal.
Item
25