Crestron CAEN-UMP1X2-DIN-PWS 제품 설명서 - 페이지 12
{카테고리_이름} Crestron CAEN-UMP1X2-DIN-PWS에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron CAEN-UMP1X2-DIN-PWS 20 페이지. Caen automation enclosure mounting kit for 4-series automation processor and hub
Crestron CAEN-UMP1X2-DIN-PWS에 대해서도 마찬가지입니다: 시작하기 (2 페이지)
페이지 인쇄
Ground wire with ring connectors
l
One screw
l
To wire the DIN rail products:
WARNING: To avoid fire, shock, or death, turn off power at circuit breaker or fuse and test
that power is off before wiring!
1. Connect the 2-wire cable from the DIN-AP4 PWR input (2-pin terminal block) to the
DIN-PWS30-277 power output (flying leads).
Ensure the wires to the DIN-PWS30-277 terminals are fully inserted:
Connect the black wire to the - (negative) terminal using a small, flat-head
l
screwdriver. Tighten to 3 in.-lbs (0.34 nm).
Connect the red wire to the + (positive) terminal using a small, flat-head
l
screwdriver. Tighten to 3 in.-lbs (0.34 nm).
2. Connect the NET output on the DIN-AP4 to the NET HOST input on the DIN-HUB using
the 4-wire cable.
Match the terminals for both devices:
24
l
Y
l
Z
l
G
l
3. Use the tie wraps to secure loose wires from steps 1 and 2. Cut off any excess of the wrap.
12 • CAEN-UMP1X2-DIN-PWS
Product Manual — Doc. 9310A