DIGISYNTHETIC DP3200 사용자 설명서 - 페이지 9

{카테고리_이름} DIGISYNTHETIC DP3200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYNTHETIC DP3200 11 페이지. Excellent power amplifier
DIGISYNTHETIC DP3200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지), 사용자 설명서 (11 페이지)

페이지 인쇄

CONNECTOR CABLE

The following diagrams illustrate the wiring of the various types of sockets that can be

used with the DP power amplifiers.

To connect the amplifier to the mixer, always make certain to use only signal cables

(screened cables made up of two wires plus a braid screen ), not power cables (speaker

cables, normally made up of two wires, usually with a greater cross-section): the use of

unscreened cables could in fact cause annoying buzzes and background noise. We

therefore always suggest the use of balanced cables for microphones and line units

whenever possible.

To connect the amplifier to the loudspeaker enclosures, always use only power cables,

not signal cables, as in the latter case in fact, the power from the amplifiers would be

partially dispersed because of the cable's smaller cross-section.

Take care of the connector cables. Always hold them by the connectors, avoiding

pulling the wire and avoid knots and twists when coiling them: this gives the advantage of

increasing their life and reliability. Check your cables periodically, making certain that they

are in good condition, that the connectors are correctly wired and contacts perfectly

efficient: in fact, many problems and setbacks (faulty contacts, ground hum, disturbance,

etc.) are due to the use of unsuitable of faulty cables.

GROUND

INPUT

COLD (-)

HOT (+)

Balanced cannon female connector

PC OUTPUT