DIGISYNTHETIC DP45O 사용자 설명서 - 페이지 7

{카테고리_이름} DIGISYNTHETIC DP45O에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYNTHETIC DP45O 13 페이지. Professional power amplifier

2. Use high-quality loudspeaker cables to connect the load to the amplifier's outputs. Do not use shielded cable.

3. Use shielded cables to connect audio sources to the amplifier's inputs. Either balanced or unbalanced wiring can be used

as shown below.(Barrier block input connectors are available with the PM-BB accessories).

INPUT

4.1 Stereo

1. Turn down the level controls (fully counterclockwise) and

2. Set the back panel Stereo/Mono switch to Stereo.

3. Connect the input and output cables .

4. Turn on the amplifier and adjust the level for each channel using the front panel level

controls.

Your amplifier's Mono modes provide double the power of the Stereo mode in a single

channel. In Bridge-Mono mode, the outputs are wired for twice the output voltage. In

Parallel-Mono mode, the inputs are paralleled to link the two channels. Bridge-Mono

mode is provided for loads with impedance greater than 4 Ohms. Parallel-Mono mode

should be used with loads of 4 Ohms .

1. Turn down the level controls (fully counterclockwise) and

2. Set the back panel Stereo/Mono switch to Bridge-Mono.

3. Connect the input and output cables.

4. Make sure the load is balanced (neither side shorted to ground) and

black (-)

binding posts.

5. Turn on the amplifier and adjust both level controls.

1. Turn down the level controls (fully counterclockwise) and

Page 6

BALANCED

GND

FROM

PREAMPLIFIER

SHIELD

Parallel-Mono

UNBALANCED

SHIELD

PREAMPLIFIER

INPUT

SHIELD

Bridge-Mono

Only channel 1 input is used.

FROM

turn off the amplifier.

do not

turn off the amplifier.

use the