DIGISYNTHETIC DSP3200 사용자 설명서 - 페이지 9

{카테고리_이름} DIGISYNTHETIC DSP3200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYNTHETIC DSP3200 18 페이지. Integrated dsp power amplifier

III. PC SOFTWARE OPERATION

The software adopts the advanced telecommunication control technology. The

user can control the gain, EQ, crossover, delay, limiter, program management etc.

through the interface software. The below introduces establish the connection and

program management operation.

A. Establish the connection

1. Installing the Software

Run the application <>. Setup will install the DSP6 application onto your PC. You

can accept the default director y, or specify a different location to install the

application.

2. Connecting a PC

Use a standard computer cable (accessor y with the unit) to connect a PC to the

DSP amplifier.

3. Configure COM port

Click on Tools in the top menu bar, and select COM Setup... to open the COM Setup

window. The application uses COM1 on the PC by default. If necessar y, you can

change the COM port used by the application. Click the COM Select: COM1 pull-

down box in the COM Setup window, all the serial ports available in the PC list

automatically, then select the desired COM port and click OK button.

Select Search...to open search function that will find out all the units in the net. The

multiple units with the same Address (master ID) and different Sub Address (slave ID)

can not be identified. You can identify such units only from the Sub Address (slave

ID), please keep the Sub Address (slave ID) so that you can control such units when

connecting with PC