Sharp 13L-M150 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Sharp 13L-M150에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp 13L-M150 34 페이지.

페이지 인쇄

Sub-Brightness Adjustment

1. Receive a good local channel.

2. Make sure the customer brightness control is set to

center position.

3. Enter the service mode and select the service

adjustment "S04".

4. Adjust "S04" data value to obtain normal brightness

level.

Vertical-Size Adjustment

1. Receive a good local channel.

2. Enter the service mode and select the service

adjustment "S09".

3. While observing the top and bottom of the screen,

adjust "S09" data value to proper vertical size.

Vertical Phase Adjustment

1. Enter the service mode and select the service

adjustment "S06".

2. Adjust data value to "00"~"03" so that picture is

approximate center.

Note: This must be set "00"~"03" when adjust

another data retrace line will be appear.

Horizontal Position Adjustment

1. Receive a good local channel.

2. Enter the service mode and select the service

adjustment "S07".

3. Adjust "S07" data value so that picture is centered.

Caption Position Adjustment (Horizontal)

1. Receive a good local channel.

2. Enter the service mode and select the service

adjustment "S18".

3. A black text box appears on the screen. (see Figure

B. below)

4. Adjust "S18" data value so that text box is positioned

in the center of the screen.

3.58MHz Trap Adjustment

1. Receive a good local channel.

2. Enter the service mode and select the service

adjustment "S16".

3. This is a two position adjustment, "00" is ON, "01" is

OFF.

4. Adjust data value to "00" for normal viewing.

Sharpness, Audio Balance, Energy Save

Offset, DDE Offset, OSD Setup, Tuner

Setup and Option Adjustments

1. Receive a good local channel.

2. Enter the service mode and select the service

adjustments "S05" for sharpness, "S17" for balance,

"S20" for energy save offset, "S21" for DDE offset,

"S22" for OSD setup, "S23" for tuner and "OP" for

option.

» Sharpness Adjustment

3. Adjust data value to "24" (center of data range) for

sharpness adjustment.

» Audio Balance Adjustment

4. Adjust data value to "20" (center of data range) for

Audio balance adjustment.

» Energy Save Offset Adjustment

5. Adjust data value to "23".

» DDE Offset Adjustment

6. Adjust data value to "03".

» OSD Setup Adjustment

7. Adjust data value to "00".

» Tuner Setup Adjustment

8. Adjust data value to "00".

» Option Adjustment

9. Adjust data value to "02".

Figure B.

13L-M100/150

CL13M10/15

14ML10