Sharp 14V-R70M 서비스 매뉴얼 - 페이지 29

{카테고리_이름} Sharp 14V-R70M에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp 14V-R70M 43 페이지.

DESCRIPTION OF SCHEMATIC DIAGRAM

NOTES:

1. The unit of resistance "ohm" is omitted.

(K=k W =1000 W , M=M W )

2. All resistors are 1/16 watt, unless otherwise noted.

3. All capacitors are m F , unless otherwise noted.

(P=pF= mm F)

4. (G) indicates ± 2% tolerance may be used.

indicates line isolated ground.

VOLTAGE MEASUREMENT CONDITIONS:

1. All DC voltages are measured with DVM connected

between points indicated and chassis ground, line

voltage set at 120V AC and all controls set for normal

picture unless otherwise indicated.

2. All voltages measured with 1000 m V B & W or Color

signal.

WAVEFORM MEASUREMENT CONDITIONS:

Photographs taken on a standard gated color bar

signal, the tint setting adjusted for proper color. The

wave shapes at the red, green and blue cathodes of

the picture tube depend on the tint, color level and

picture control.

indicates waveform check points (See chart,

waveforms are measured from point indicated to

chassis ground.)

Œ AND SHADED (

= SAFETY RELATED PARTS.

MARK= X-RAY RELATED PARTS.

DRGANNES MARQUES Œ ET HACHRES (

PIECES RELATIVES A LA SECURITE.

MARQUE

: PIECS RELATIVE AUX RAYONS X.

This circuit diagram is a standard one, printed circuits

may be subject to change for product improvement

without prior notice.

14V-R70M

) COMPONENTS