DIGISYNTHETIC DS212 사용 설명서 - 페이지 10

{카테고리_이름} DIGISYNTHETIC DS212에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYNTHETIC DS212 13 페이지. 24-bit dual engine automatic feedback destroyer/parameter eq

페이지 인쇄

Display

Program0

Program1

Program2

Program3

The fifth page of the MIDI menu shows the "SAVE" symbol in the display. The "SAVE OFF" disable the

reception of controller #28, and therefore protects the user presets from being modified via MIDI.

Accordingly, the "SAVE ON " value enables MIDI controller #28 so that you can modify or replace presets

with a remote MIDI device or a sequencer. In this case the actual settings will be stored directly to the location

that corresponds to the controller value.

ATTENTION! Since the "store enable" mode allows you to access memory locations directly via MIDI,

it is possible that stored presets will be replaced or altered if controller #28 messages are sent on the

same MIDI channel. The purpose of this mode is to facilitate MIDI backup and restore operations

without express conformation at the DS212. It is therefore recommended to disable "SAVE OFF"

mode as soon as the intended data transfer has ended. This is done automatically when you switch

off the DS212.

On the sixth, and presently the last, page you can access the "System Exclusive"(SYSEX) functions. This

is indicated by a "d" (for dump) in the display.

means that no SYSEX data will be sent or accepted.

-SYS OFF

will enable the DS212 to receive data. When STORE is pressed the unit will wait for data; this

-SYS RXD

is shown by "RXD" flashing.

-SYS TXD

will enable the DS212 to send a "bulk dump". Start your sequencer and press STORE on the

DS212 to start the transmission. OFF will display when transmission is completed.

During a bulk dump, all audio functions of the DS212 will be deactivated.

To load these settings again, press STORE and start your sequencer, If your press IN/OUT button again,

you will leave the MIDI setup. You can at all times press any other key to leave the MIDI setup directly.

DS212 has total command of MIDI ability and able to combine & work with any MIDI system.

MIDI IN

Any MIDI data sent to the DS212 (sequencer, MIDI footswitch, etc) are received via the MIDI IN jack.

For example, when you wish to use the DS212 as an effects devices for our guitar rack, you can connect

the MIDI IN jack to a MIDI footswitch that allows for selecting program presets. If your rack includes an

-other MIDI effects devices (e.g. a multi-effects processor), the data sent from the MIDI footswitch can be

routed via the DS212 MIDI THRU jack to your multi-effects processor.

MIDI THRU

The MIDI THRU jack is used to loop through incoming MIDI data; i.e. any control received at the MIDI

IN of the DS212 can be transmitted via MIDI THRU jack to other MIDI devices or instruments.

MIDI OUT

The MIDI OUT jack allows for transmitting MIDI data that originate from the DS212.

Modes

Program changes are not transmitted

Program changes are received but not transmitted

Program changes are transmitted but not received

Program changes are transmitted and received

Fig.3.3 Program change settings

Page 9