Crestron TMK-12L 설치 매뉴얼 - 페이지 9
{카테고리_이름} Crestron TMK-12L에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron TMK-12L 16 페이지. Trim ring mount kits
Crestron TMK-12L에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지)
페이지 인쇄
Crestron TMK-12L & WMKT-12L
Installation Guide – DOC. 6360A
1. Verify that the cutout in the drywall is as clean and level as possible.
2. Insert the symmetrical trim ring into the opening, as shown in the
illustration below.
Insert Trim Ring into Opening
NOTE: The required PMK-12L or BB-12L is not shown.
3. When the trim ring is in position, bend the top two flanges of the ring
upward and the bottom two flanges downward.
•
If mounting into the PMK-12L, bend the flanges approximately 90
degrees.
•
If mounting into the BB-12L, bend the flanges back as far as they can
go.
4. Run the necessary cables for the touchpanel and secure them behind the
drywall.
5.
The touchpanel can be installed using the eight tapped holes in the
TMK-PMK-15L (or BB-15L). Refer to the latest revision of the
TPS-12L/15L/17L Operations Guide (Doc. 6355),
TPS-12G/15G/17G-QM-L Operations Guide (Doc. 6356) or the TPMC-12L
Operations Guide (Doc. 6686) for touchpanel installation details. Refer also
to the comprehensive illustration shown on the following page.
Trim Ring Mount Kits
NOTE: MAKE DRYWALL CUTOUT AS
LEVEL AND CLEAN AS POSSIBLE. THE
TRIM RING ONLY ALLOWS MINOR
ADJUSTMENTS OF THE TOUCHPANEL.
DRYWALL
TRIM RING
(2013001)
Trim Ring Mount Kits: TMK-12L & WMKT-12L • 5