DIGISYSTEM DSO-D Series 사용 설명서 - 페이지 2

{카테고리_이름} DIGISYSTEM DSO-D Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYSTEM DSO-D Series 3 페이지. Hot air oven

5.2.3 You will see

value. Press

5.2.4 You will see

finished.

Remark: If you want to interrupt the timer mode, you can press

6. After finishing the work, please press "ON/OFF Button" to turn off the power, and then the "Power

indicator' becomes red.

Remark:

1. When the "OUT1" indicator on the display screen is sparkling, it means that the instrument is heating.

2. After the PV value reaches to SV value and tends to be stable, the "ALM1" indicator lamp will appear if the

PV value exceeds the SV value by setting point (10℃). In this situation, please turn the power off, open

the door and wait for about 30 minutes, and then restart it.

3. If you feel the PV value is much higher or lower than the SV value, you can adjust the "Air vent" on the

back of machine to balance the temperature. That is, if the PV value is too high, you can open the "Air

vent"; if the PV value is too low, you can close the "Air vent".

Maintenance and care:

Keep the machine clean all the time, so no routine maintenance is required. Cleaning can be done with a

damp cloth. Avoid the use of solvents as they may damage the product housing and inner chamber.

Circuit Diagram:

DIGISYSTEM LABORATORY INSTRUMENTS INC.

. Use

key to adjust the time value. Press

to next setting.

. Press

and you will see

www.digisystemlab.com

to enter the

. The setting is

to be continuous mode.

REV.1-2017