Crestron TMK-6X-DSW 설치 매뉴얼 - 페이지 8

{카테고리_이름} Crestron TMK-6X-DSW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron TMK-6X-DSW 16 페이지. Trim ring kits for the tps-6x-dsw

Trim Ring Mount Kits for the TPS-6X-DSW

4 • Trim Ring Mount Kits for the TPS-6X-DSW: TMK/WMKT-6X-DSW

Installation

This section provides an installation procedure for each Trim Ring Mount Kit. The

"TMK-6X-DSW Procedure" starts below and the "WMKT-6X-DSW Procedure"

starts on page 6. Be sure to review each procedure before starting.

TMK-6X-DSW Procedure

This section provides the necessary steps for the assembly of the TMK-6X-DSW

with either the BB-6X-DSW or PMK-6X-DSW. It is assumed that the BB-6X-DSW

or PMK-6X-DSW has been secured to the stud according to the instructions in the

latest revisions of their Installation Guides (Doc. 6728 and Doc. 6778 respectively).

It is also assumed that drywall is in place and a cutout for the TPS-6X-DSW is made

in the drywall.

Complete the steps in the order provided. The only tool required and not supplied is

a level.

CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity

above and below the TPS-6X-DSW for heat dissipation.

NOTE: When installing into the PMK-6X-DSW, verify that the 18 AWG bus wire

securing the cables for the wall mount docking station remains attached.

1. Verify that the cutout in the drywall is as level as possible.

2. Insert the symmetrical trim ring into the opening, as shown in the

illustration below.

Insert Trim Ring into Opening

DRYWALL

NOTE: The required PMK-6X-DSW or BB-6X-DSW is not shown in the

illustration above.

Crestron TMK/WMKT-6X-DSW

IMPORTANT

MAKE DRYWALL CUTOUT

AS LEVEL AND CLEAN AS

POSSIBLE. THE TRIM RING

ONLY ALLOWS MINOR

ADJUSTMENTS OF THE

TPS-6X-DSW.

TRIM RING

(2022808 )

Installation Guide – DOC. 6780A