DIGISYSTEM AFV2000 사용 설명서 - 페이지 7
{카테고리_이름} DIGISYSTEM AFV2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYSTEM AFV2000 9 페이지. Variable frequency vibrators power supply
DIGISYSTEM AFV2000에 대해서도 마찬가지입니다: 사용 설명서 (9 페이지), 사용 설명서 (9 페이지)
페이지 인쇄
PROBLEMS SOLUTION
fault
Led DL2 switches regularly on and off
At power on the led DL2 doesn't switch
momentary on and DL1 doesn't switches
at all
At power on the led DL1 is off and led
DL2 switches momentary on, but
vibration doesn't start
At power on the led DL1 switches on
and led DL2 switches momentary on,
but vibration doesn't start
If actions remarked on the table doesn't resolve the problem you may contact factory
digisystem srl (e-mail
OPENING INSTRUCTIONS
As on the electronic card there are some capacitors with high voltage applied (presence of
residuary energy, danger of strike) you must wait at least 4 - 5 minutes after the device is
disconnected from the power supply, before opening the box.
Remove the four screws on the panel.
Downloaded from StockCheck.com
start command
functional
anomaly
Overload
Decrease reference voltage to
condition
decrease the output power
Device not
Verify mains supply and input
supplied
fuses; to locate fuses F1 see
instructions to open the device
There is not
Place switch SW2 to on or send
a start command from input
Vibrator not
Check wiring from power
supplied
supply to vibrator; if the
problem is not there may be
there is a failure on drivers into
) we will help you.
7
What to do
cable
the power supply