Sharp CD-G10000 운영 매뉴얼 - 페이지 35

{카테고리_이름} Sharp CD-G10000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-G10000 47 페이지. Mini component system

페이지 인쇄

Sequential recording from several discs:

1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page

34.

2 Within 5 seconds, press the

To perform programmed recording:

1 Program discs and tracks (see pages 25, 29).

2 Press the

button.

3 Press the

button.

To stop recording:

Press the

button.

The disc and tape will stop.

Recording from the radio

Tune in to the desired station (see page 30).

Load a cassette into the TAPE 2 cassette compartment

with the side to be recorded on facing you.

Wind past the leader of the tape, on which recording cannot be

performed.

Press the

button.

Recording will be paused.

Press the

button to start recording.

To interrupt recording:

Press the

button.

To resume recording, press the

To stop recording:

Press the

button.

Note:

If you hear a whistling noise while recording an AM station, move

the AM loop antenna.

You can record from TAPE 1 to TAPE 2.

button.

To stop dubbing:

Press the

TAPE 1 and TAPE 2 will simultaneously stop.

button.

1 Load the tape to be erased into the TAPE 2 cassette compart-

2 Press the TAPE (1

3 Press the

4 Press the

Note:

Make sure that the TAPE 1 is not in use.

Dubbing from tape to tape

Press the ON/STAND-BY button to turn the power on.

Load a prerecorded cassette

into the TAPE 1 cassette com-

partment. Insert a blank tape

into the TAPE 2 cassette com-

partment.

It is recommended that the recording tape is the same length as

the master tape.

Press the TAPE (1

2) button until "TAPE 1" appears on

the display.

Press the

button.

Recording will be paused.

Press the

button to start dubbing.

button.

Erasing recorded tapes

ment with the side to be erased facing toward you.

2) button until "TAPE 2" appears on the dis-

play.

button.

button to start erasing.

CD-G10000

CP-G10000S

TAPE 1

TAPE 2