Sharp CD-G15000 운영 매뉴얼 - 페이지 19

{카테고리_이름} Sharp CD-G15000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-G15000 48 페이지. Speaker system
Sharp CD-G15000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Setting the clock (Remote Control only)

In this example, the clock is set for the 12-hour (AM 12:00) display.

Press the ON/STAND-BY button to turn the power on.

Press the CLOCK/TIMER button.

Within 10 seconds, press the

select "CLOCK", and press the MEMORY button.

Press the

button to select 12-hour or 24-hour

display and then press the MEMORY button.

"AM 12:00"

The 12-hour display will appear.

(AM 12:00 - PM 11:59)

"AM 0:00"

The 12-hour display will appear.

(AM 0:00 - PM 11:59)

"0:00"

The 24-hour display will appear.

(0:00 - 23:59)

Press the

press the MEMORY button.

Press the

1 hour. Hold it down to advance continuously.

Press the

then press the MEMORY button.

Press the

1 minute. Hold it down to change the time in 5-minute intervals.

To conﬁrm the time display:

[When the unit is in the stand-by mode]

Press the CLOCK/TIMER button.

button to

The time display will appear for about 10 seconds.

[When the power is on]

Press the CLOCK/TIMER button.

Within 10 seconds, press the

time. The time display will appear for about 10 seconds.

Note:

The "CLOCK" will appear or time will ﬂash to conﬁrm the time

display when the AC power supply is restored after a power failure

or unplugging the unit. If incorrect, readjust the clock as follows.

To readjust the clock:

Perform "Setting the clock" from step 1. If the "CLOCK" does not

appear in step 3, step 4 (for selecting the 12-hour or 24-hour

display) will be skipped.

To change the 12-hour or 24-hour display:

1 Clear all the programmed contents. [Refer to "Clearing all the

memory (reset)" on page 44 for details.]

2 Perform "Setting the clock" from step 1.

button to adjust the hour and then

button once to advance the time by

button to adjust the minutes and

button once to advance the time by

button to display the

CD-G15000

CP-G15000