Sharp CD-MPX500H 운영 매뉴얼 - 페이지 14
{카테고리_이름} Sharp CD-MPX500H에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-MPX500H 48 페이지. Mini component system
페이지 인쇄Setting the clock (Remote control only)
CD-MPX200H
CD-MPX200H3
CD-MPX500H
ENGLISH
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "CLOCK", and press the MEMORY button.
4
Press the
12-hour display and then press the MEMORY button.
"0:00"
"AM 12:00"
"AM 0:00"
E-11
or
or
button to select 24-hour or
The 24-hour display will appear.
(0:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press the
then press the MEMORY button.
Press the
1 hour. Hold it down to advance continuously.
6
Press the
then press the MEMORY button.
Press the
1 minute. Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
button to
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour
display) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 42 for details.]
2 Perform "Setting the clock" from step 1.
or
button to adjust the hour and
or
button once to advance the time by
or
button to adjust the minutes and
or
button once to advance the time by
or
button to display the