Sharp CD-SW300H 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Sharp CD-SW300H에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-SW300H 2 페이지. Mini component system
Sharp CD-SW300H에 대해서도 마찬가지입니다: 운영 매뉴얼 (48 페이지), 운영 매뉴얼 (48 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
Listening to a CD or MP3/WMA disc
1
Press the CD button.
2
Press the
1 button and within 5 seconds, press the
open the disc tray 1.
3
Place the disc on the disc tray 1, label side up.
4
Press the
button to close the disc tray 1.
5
You can place discs on trays 2 - 5 by following steps 2 - 4.
6
Press the
button to start playback.
/
Listening to a cassette tape
1
Open the cassette compartment by
pushing the area marked " ".
2
Load a cassette into the TAPE 1 compartment
or TAPE 2 compartment with the side to be
played facing towards you.
3
Press the TAPE (1
2) button to select the cassette you want to
listen to.
4
Press the
/
(TAPE
) button to start playback.
CD-SW300E QG
button to
12 cm (5")
8 cm (3")
TAPE 1
TAPE 2
2
Listening to the radio
FM stereo mode indicator
FM stereo receiving indicator
1
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
2
Press the TUNING (
or
) button to tune in to the desired station.
When the TUNING (
or
) button is pressed for more than 0.5 sec-
onds, scanning will start automatically and the tuner will stop at the
first receivable broadcast station.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
" " will appear when an FM broadcast is in stereo.
If trouble occurs
When this product is subjected to strong external interference (me-
chanical shock, excessive static electricity, abnormal supply voltage
due to lightning, etc.) or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1.
Set the unit to the stand-by mode and turn the power on again.
2.
If the unit is not restored in the previous operation, unplug
and plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
Clearing all the memory (reset)
1.
Press the ON/STAND-BY button to enter the power stand-by
mode.
2.
Whilst pressing down the
the TUNER (BAND) button until "CLEAR ALL" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Maintenance
Routine maintenance is required for continued optimum perfor-
mance, refer to the operation manual.
2/14/06, 3:31 PM
button and the 7 7 7 7 7 button, press