Sharp XL-S10 운영 매뉴얼 - 페이지 13
{카테고리_이름} Sharp XL-S10에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp XL-S10 31 페이지. Sharp deck operation manual xl-s10
Sharp XL-S10에 대해서도 마찬가지입니다: 서비스 매뉴얼 (44 페이지)
페이지 인쇄
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the CLOCK button and within 5 seconds, press the
MEMORY button.
2
Within 1 minute, press the PRESET (
lect 12-hour or 24-hour display and then press the MEMO-
RY button.
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
Note that this can only be set when the unit is first installed or it
has been reset. (Refer to "Clearing all the memory (reset)" on
page 28.)
3
Within 1 minute, press the PRESET (
just the hour and then press the MEMORY button.
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
4
Within 1 minute, press the PRESET (
just the minutes and then press the MEMORY button.
The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
or
) button to se-
Note:
The "AM 12:00" or time will flash when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 28 for details.]
2 Perform "Setting the clock" from the beginning.
XL-S10
or
) button to ad-
or
) button to ad-
13