Sharp XL-UH2080H 운영 매뉴얼 - 페이지 28

{카테고리_이름} Sharp XL-UH2080H에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp XL-UH2080H 40 페이지.

페이지 인쇄

1. Listening to the Radio

Using the Radio Data System (RDS) (continued)

XL-UH2080H

To recall stations in memory

To specify programmed types and select stations (PTY search):

You can search a station by specifying the programme type (news,

sports, traffic programme, etc. ... see pages 29 - 30) from the stations

in memory.

Press the TUNER (BAND) button to select the FM band.

Press the RDS PTY button on the remote control.

"SELECT" and "PTY TI" will appear alternately for about 6

seconds.

Within 6 seconds, press the PRESET (

select the programme type.

Each time the button is pressed, the programme type will

appear. If the button is held down for more than 0.5 seconds,

the programme type will appear continuously.

Whilst the selected programme type is flashing (within 6

seconds), press the RDS PTY button again.

After the selected programme type has been lit for 2 seconds,

"SEARCH" will appear, and the search operation will start.

Advanced Features

Notes:

If the display has stopped flashing, start again from step 2. If the

unit finds a desired programme type, the corresponding channel

number will flash for about 4 seconds, and then the station name

will flash for 7 seconds, which will remain lit.

If you want to listen to the same programme type of another

station, press the RDS PTY button whilst the channel number or

station name is flashing. The unit will look for the next station.

If no station can be found, "NOT FOUND" will appear for 4

seconds.

If you select the traffic programme:

If you select the traffic programme (TP) in step 3, "TP" will appear.

(This does not mean that you can listen to the traffic information at

that time.)

When the traffic information is broadcast, "TA" will appear.

) button to

To specify station names and select stations manually:

You can select a station by specifying the name (BBC R1, BBC R2,

etc.) from the stations stored in memory.

Before starting this operation, you must store one or more station

names in memory.

1 Press the TUNER (BAND) button to select the FM band.

2 Press the PRESET (

select a desired station.

3 The station name will be displayed for 6 seconds. Then the

display will change.

) button on the remote control to