Sharp AL-1035-WH A 운영 매뉴얼 - 페이지 35
{카테고리_이름} Sharp AL-1035-WH A에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AL-1035-WH A 50 페이지. Digital multifunctional system
Sharp AL-1035-WH A에 대해서도 마찬가지입니다: 수동 시작 (28 페이지)
페이지 인쇄
MACHINE/COPYING PROBLEMS
The following problems are related to the general operation of the machine and copying.
Problem
The machine does not operate.
Copies are too dark or too light.
Blank copies.
Part of the image is cut off or there
is too much blank space.
Wrinkles appear in the paper or
the image disappears in some
places.
Paper misfeed.
Cause and solution
The machine is not plugged into a power socket.
→ Plug the machine into a grounded power socket.
Power switch is turned OFF.
→ Turn the power switch ON.
Warming up.
→ Indicates that the machine is warming up. Copies cannot be
made until the machine has finished warming up.
The machine is in auto power shut off mode.
→ In auto power shut off mode, press any key to resume normal
operation.
Select the correct original type.
→ Press the [DENSITY] key (
manually.
The original is not placed with face down on the
document glass.
→ Place the original face down on the document glass.
The original was not placed in the correct position.
→ Place the original correctly.
No appropriate ratio was selected according to the size of
the original and the size of the paper.
→ Press the [MODE SELECT] key to have the copy made using the
appropriate ratio for the original and paper.
The paper is outside of the specified size and weight
range.
→ Use copy paper within the specified range.
Paper is curled or damp.
→ Do not use the curled or crimped paper. Replace it with dry copy
paper. If the machine is not used for a long time, remove the
paper from the feed tray, put it into a bag and store in a dark place
to prevent moisture absorption.
Misfeed occurs.
→ To clear the misfeed, please refer to "MISFEED REMOVAL".
The paper is outside of the specified size and weight
range.
→ Use copy paper within the specified range.
Paper is curled or damp.
→ Do not use the curled or crimped paper. Replace it with dry copy
paper. If the machine is not used for a long time, remove the
paper from the feed tray, put it into a bag and store in a
dark/shady place to prevent moisture absorption.
Paper is not loaded properly.
→ Make sure that the paper is properly loaded.
Torn pieces of paper inside the machine.
→ Remove all the torn pieces of the misfeed paper.
Too much paper is loaded into the feed tray.
→ If the stack height of paper exceeds the upper limit of the paper
guide, remove some of the paper to keep the stack height within
the limit.
The paper guide does not match the width of the paper.
→ Adjust the paper guide to match the width of the paper.
Output tray is not expanded.
→ Expand the output tray.
34
TROUBLESHOOTING
) to select proper exposure
Page No.
–
6
6
6
16
15
15
17
7
–
41
7
–
9
41
9
9
7