Sharp AR-203E X 프린터 사용 설명서 - 페이지 32

{카테고리_이름} Sharp AR-203E X에 대한 프린터 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-203E X 44 페이지. Digital multifunctional system
Sharp AR-203E X에 대해서도 마찬가지입니다: 온라인 매뉴얼 (39 페이지), 주의 사항 리플렛 (37 페이지)

페이지 인쇄

Faint, Uneven or Smeared Print Output

If print output is faint, uneven or smeared, follow the steps listed below.

CHECK1 Has the printer driver been specified to suit

both paper and the print job?

You can select "Draft", "Normal" or "Photo" for the

print quality in the "Advanced" tab of the printer

driver setup screen. When "Photo" is selected, you

can click the "Image Adjustment" button and adjust

the brightness and contrast in the dialog box that

appears. Adjust these settings appropriately for your

print data and try printing again.

Reference:"Printer Driver Settings" (p.4)

CHECK2 Is the paper curled?

If the paper is curled, straighten it up and set it in the

unit again.

CHECK3 Is the paper too thick or too thin?

Only paper weighing from 56 g/m

(15 lbs. to 21 lbs.) can be used in the paper tray.

Only paper weighing from 56 g/m

(15 lbs. to 34.5 lbs.) can be used in the multi-bypass

tray.

CHECK4 Is the developer replacement required

indicator lit?

When the developer replacement required (

indicator lights up, the developer should be

replaced. DEVELOPER REPLACEMENT SHOULD

ONLY BE DONE BY AN AUTHORISED SHARP

SERVICE TECHNICIAN. Contact your authorised

service representative as soon as possible.

CHECK5 Is it near time to replace the toner cartridge?

CHECK6 Is the maintenance indicator lit?

CHECK7 Did you set sufficient margins in the paper

to 80 g/m

to 128 g/m

)

When it is near time to replace the toner cartridge,

the toner cartridge replacement required (

indicator will light up on the unit operation panel.

When it is time to replace the cartridge, the indicator

will blink. Replace the cartridge and try printing

again.

Reference:See "TONER CARTRIDGE

REPLACEMENT", in the Operation Manual.

When the maintenance (

service by an authorised SHARP service technician

is required. Contact your authorised service

representative as soon as possible.

settings of your application?

If the margins are set outside of the quality

guaranteed area, smudges or smears may appear

at the upper and lower edges of the paper.

When selecting the paper settings in the application,

set the margins from the top, bottom, left and right

edges of the paper to 4 mm (5/32").

)

) indicator lights up,