Sharp AR-AR-M355N 빠른 참조 매뉴얼 - 페이지 15
{카테고리_이름} Sharp AR-AR-M355N에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-AR-M355N 31 페이지. Digital multifunctional imager
페이지 인쇄Simulation List (Main/Sub) (cont'd)
66
26
Used to register external telephone numbers for Modem dial-in. (Only when FAX is
installed.) Not used in the market. (For development.)
27
Used to register the transfer number for voice warp. (Only when FAX is installed.) Not
used in the market. (For development.)
29
Used to clear data related to an address book (one-touch registration, program
registration/expansion, relay memory box registration, each table content.)
30
Used to check the change in the TEL/LIU status. (Only7 when FAX is installed.)
31
Used to check the relay operation. (Only when FAX is installed.)
32
Used to check the receive data (fixed data) from the line. (Only when FAX is installed.)
33
Used to check the signal (BUSY TONE / CNG / CED / FNET / DTMF) detection. (Only
when FAX is installed.)
34
Used to measure the communication time of test image data. (Only when FAX is
installed.)
35
Modem program rewriting. (Only when FAX is installed.) Not used in the market. (For
development.)
36
Used to check interface between MFPC controller and MDMC. (Check of the data line or
the command line.) (Only when FAX is installed.)
39
Used to set the destination specifications. (Only when FAX is installed.)
Quick Reference Guide: AR-M355N/M455N
66
39
Used to set the destination specifications. (Only when FAX is installed.)
42
PIC program rewriting. (Only when FAX is installed.)
43
PIC adjustment value writing. (Only when FAX is installed.)
67
2
Used to check the operation of the parallel I/F o the printer. (This simulation is for
production only, and requires a special tool for execution.) (Not used in the market.)
11
Used to set YES/NO of the parallel I/F select signal of the printer.
16
Used to check the operation of the network card.
Simulation List (Pg. 10 of 10)
15