Sharp AR-AR-M355N 빠른 참조 매뉴얼 - 페이지 25

{카테고리_이름} Sharp AR-AR-M355N에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-AR-M355N 31 페이지. Digital multifunctional imager

Flash ROM Version Up (Firmware ROM Upgrade) Procedures (cont'd)

Upgrade Procedure 1: Collectively Writing with Each ROM Inserted into the Specified Slot

Note:

Make certain all of the ROMs on the PCU, FAX, and scanner are operating ROMs. An empty ROM (a ROM that cannot boot the machine)

cannot be used for writing.

Setup

1. Set the Diag Mode Switch DIP switch (located on the left side on the back of the machine) to the diag mode. (See Setting the DIP Switches.)

2. Make certain the scanner unit is connected to the machine.

3. When a FAX is installed, make certain the FAX unit is connected to the machine.

4. Connect the PC and Controller PWB with the Centronics cable or USB cable.

5. Power ON the PC.

6. Power ON the machine to be updated.

Update Procedures

1. When the machine is booted, the following display is shown.

2. Press the MENU key a few times to display the following windows.

Note: If using File2PRN.EXE, select the connection type (USB or

parallel) with the Up/Down select key.

Quick Reference Guide: AR-M355N/M455N

3. Press OK key, and the following window is displayed.

Note 1:

Flash ROM (cont'd)

The LED flashes and the display is changed

sequentially (as shown below) when files are

transferred from the PC by Fcopy.EXE or

File2PRN.EXE.