Sharp AR-C260 네트워크 스캐너 운영 - 페이지 18
{카테고리_이름} Sharp AR-C260에 대한 네트워크 스캐너 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C260 42 페이지. Color adjustment
Sharp AR-C260에 대해서도 마찬가지입니다: 주요 운영자 매뉴얼 (19 페이지), 프린터 사용 설명서 (50 페이지), 소프트웨어 설치 매뉴얼 (25 페이지), 컬러 관리 매뉴얼 (8 페이지), 설치 매뉴얼 (15 페이지), 사용자 설명서 (8 페이지)
페이지 인쇄
SENDING AN IMAGE
BASIC TRANSMISSION METHOD
Make sure the machine is in scanner
1
mode.
Load the original.
2
NOTE
You cannot load documents in both the reversing
automatic document feeder and on the document
glass and send them in a single transmission.
3
Check the original size.
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO
A4
ORIGINAL
NOTE
G To scan a two-sided original (when a reversing
automatic document feeder is installed), refer to
page
19.
G To rotate the document image 90° before
transmission, see
page
4
If needed, adjust the resolution setting.
(Refer to
page
22.)
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO
A4
ORIGINAL
When
the
[IMAGE
SEND] key light is on,
the
machine
is
in
scanner mode. If the
light is not on, press the
[IMAGE SEND] key.
For detailed information
on loading an original,
refer to page 4-6 of
"Operation manual (for
general information and
copier operation)".
The
original
size
is
automatically detected.
If you loaded a non-
standard size document
or wish to change the
scanning size, touch the
[ORIGINAL] key and set
the
document
size.
(Refer to
page
20.)
20.
The initial factory setting
is "LOWER".
TABLE OF CONTENTS
If needed, adjust the exposure setting.
5
(Refer to
page
21.)
AUTO
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO
A4
If needed, select the file format. (Refer to
6
page
23.)
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO
A4
ORIGINAL
7
Touch the [SENDER LIST] key.
DIRECTORY
ADDRESS REVIEW
SENDER LIST
-MAIL ADDRESS
NOTES
G You can omit selection of a sender (go directly to
step
10). In this case, the default sender
information stored with the key operator program
is automatically transmitted.
G Up to 20 senders can be stored using the Web
page.
(page
12)
8
Touch a key to select a sender.
DER LIST
1 GROUP
SHARP PPD
2 GROUP
9
Touch the [OK] key.
OK
1 GROUP
16
The initial factory setting
is "AUTO".
The initial factory setting
is "PROGRAMMED".
This
step
is
not
necessary for Scan to
FTP or Scan to Desktop.
Go directly to
step 10
(page 17).
(page
38)
The
touched
key
is
highlighted. If you made a
mistake, touch the correct
key. The highlighting will
move to the new key.
The selected sender will be
the sender of the e-mail.