Sharp AR-C260 프린터 사용 설명서 - 페이지 15
{카테고리_이름} Sharp AR-C260에 대한 프린터 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C260 50 페이지. Color adjustment
Sharp AR-C260에 대해서도 마찬가지입니다: 네트워크 스캐너 운영 (42 페이지), 주요 운영자 매뉴얼 (19 페이지), 소프트웨어 설치 매뉴얼 (25 페이지), 컬러 관리 매뉴얼 (8 페이지), 설치 매뉴얼 (15 페이지), 사용자 설명서 (8 페이지)
페이지 인쇄
N-Up Printing
Each page is reduced to allow multiple pages to
be printed on each sheet. The pages are printed
in "Z" order on each sheet.
The following five settings are available:
[1-Up], [2-Up], [4-Up], [6-Up], [8-Up].
Default setting: 1-Up
Example: 4-Up
Border
[Border]
This setting is greyed out when [1-Up] is selected.
Select whether or not to print a border around each
page when a setting other than 1-Up is selected.
Default setting: Not selected
User Settings
The user can store up to 30 sets of settings,
allowing the settings to be easily changed by
simply selecting the desired set.
Default setting: Factory Defaults
[Save]
Save the settings under the name that appears in
"User Settings".
Up to 20 characters can be entered for the name.
If none of the settings have been changed (the
settings are still the factory defaults), this button
will be greyed out.
When [Delete] appears in the button, it can be
clicked to delete a stored set of user settings.
Auto Job Control review
Select this to have the job control screen
constantly displayed when printing from the
printer driver.
Default setting: Not selected
TABLE OF CONTENTS
SELECTING PRINTING FUNCTIONS Frequently used settings (continued)
BEGINNING OF CHAPTER
Finishing
Configure settings for staple or punch finishing.
[Binding Edge]
When automatic two-sided printing is performed,
the [Binding Edge] setting is used to determine
how the top and bottom edges of the front and
back sides are positioned. The relation between
the document and each of the settings is as
follows:
Original image
[Left]
[Right]
Left binding
Rignt binding
Binding edge
Binding edge
Default setting: Left
[Staple]
[None]............ Do not staple.
[1 Staple] ....... Staple in one place.
[2 Staples] ..... Staple in two places.
When [1 Staple] or [2 Staples] is selected, the
[Collate] setting is automatically activated.
Default setting: None
[Punch]
Configure the settings for the Punch function.
When this is selected, the document will be hole-
punched. The Collate setting is automatically
activated when Punch is selected.
Default setting: Not selected
[No Offset]
Select this setting when you do not wish sets of
collated or grouped output to be offset from each
other.
Default setting: Not selected
[Top]
Top binding
Binding edge
2-3