Sharp AR-C260M 주요 운영자 매뉴얼 - 페이지 15

{카테고리_이름} Sharp AR-C260M에 대한 주요 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C260M 19 페이지. Color adjustment
Sharp AR-C260M에 대해서도 마찬가지입니다: 네트워크 스캐너 운영 (42 페이지), 프린터 사용 설명서 (50 페이지), 소프트웨어 설치 매뉴얼 (25 페이지), 컬러 관리 매뉴얼 (8 페이지), 설치 매뉴얼 (15 페이지), 사용자 설명서 (8 페이지)

페이지 인쇄

PROGRAMS FOR COPY MODE

The key operator programs that are used for copy mode are explained in the following.

I Copy settings

OTHER FUNCTION SETTINGS

Initial status settings

The copier settings will be reset when the main

switch is turned off, when the [CA] key is pressed,

or when the auto clear interval has elapsed. Use

this program to establish new initial settings or to

return the initial settings to the factory default

settings. Paper tray, exposure mode, copy ratio,

duplex mode, and output mode default settings can

be selected.

NOTE

Even if the default state of the two-sided function

has been set to other than one-sided to one-sided

copy mode using this program, in the event that the

two-sided function of the optional duplex module/2

x 500 sheet paper drawer or the reversing

automatic document feeder has failed or has been

prohibited* from use, the default state will revert to

one-sided to one-sided copy mode.

* Disabling of document feeder (page 9)

Disabling of duplex (page 9)

Disabling of inverter (page 9)

Disabling of optional paper drawer (page 9)

Exposure adjustment

Use this program to lighten or darken copies in the

automatic exposure mode. The factory setting is

"5". "1" indicates lighter density and "9" indicates

darker density on the touch panel.

Rotation copy setting

If this program is set, the image of originals will

rotate when the orientation of the originals does not

match that of the copy paper.

(Rotation copy will function only if the auto paper

select or auto image mode has been selected.)

NOTE

For copying from A5 or 5-1/2" x 8-1/2" size originals

onto A5R or 5-1/2" x 8-1/2"R paper, this program

must be set.

Add or change extra preset ratios

Two extra preset copy ratios can be added within

both the reduction range (45% to 99%) and the

enlargement range (101% to 400%). Only added

preset copy ratios can be changed. The standard

preset copy ratios are fixed in memory and cannot

be changed.

Initial margin shift setting

Set the initial margin shift value with this program.

The value can be set from 0 mm to 20 mm in 1 mm

increments or from 0" to 1" in 1/8" increments.

If an optional duplex module/2 x 500 sheet paper

drawer (AR-D19) and duplex bypass/inverter unit

(AR-RB1) are not installed, the value for the

reverse side (side 2) is not displayed.

Erase width adjustment

Set the initial setting of the amount of the erase

area with this program.

The values can be set from 0 mm to 20 mm in 1 mm

increments or from 0" to 1" in 1/8" increments.

Setting a maximum number of copies

Use this program to limit the maximum number of

copies per copy run which can be input in the copy

quantity display.

A number from 1 to 999 can be set.