Sharp AR-C360P 소프트웨어 설치 매뉴얼 - 페이지 3

{카테고리_이름} Sharp AR-C360P에 대한 소프트웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C360P 29 페이지. Sharp ar-c360p: supplementary guide
Sharp AR-C360P에 대해서도 마찬가지입니다: 인쇄 매뉴얼 (46 페이지)

페이지 인쇄
Sharp AR-C360P 소프트웨어 설치 매뉴얼
Network Installation
Windows (cont'd)
2 Connect the Ethernet Interface
1. Switch off the printer and computer.
2. Remove the protective cover from the network
connector on the printer.
3. Connect the Ethernet cable between the print
and the Ethernet hub.
For more information, see the Configuration Guide
on the User Documentation CD.
3 Assign an IP address to the printer
If you are not using DHCP, you need to obtain an IP
Address from your network Administrator and
enter it using the front panel:
1. Confirm that the printer displays [
].
print
NOTE
Ready to
∇
2. Press
key until [
the Enter key.
3.
Continue to Setup
select
. The printer goes offline and
Yes
displays. This will take about a minute.
Setup
4. The Setup Menu displays, press
. Press ENTER.
Network Setup
∇
5. Press
to select
∇
6. Press
to select
∇
7. Press
to select
8.
TCP/IP Ethernet
ENTER.
Enable AutoIP Config?
Press ENTER.
9. The default IP Address displays. Use
change each octet. Press ENTER to proceed to
the next octet or to leave the octet unchanged.
10.
displays. Repeat instructions in step
Subnet Mask
9.
11.
TCP/IP bound to Ethernet
12.
Gateway Address
step 9.
13.Press ENTER to exit TCP/IP Setup, Protocol
Setup, and Network Setup.
14.Select
and press ENTER to Save Changes.
Yes
Press ENTER to Exit the Setup Menu.
15.Printer restarts the server and initializes.
displays.
to Print
3
] appears. Press
Admin Setup
? displays. Press ENTER to
∇
to select
. Press ENTER.
Protocol Setup
. Press ENTER.
TCP/IP Setup
. Press ENTER.
Ethernet Setup
displays. Select
and press
YES
displays. Select
displays. Press ENTER.
displays. Repeat instructions in
Running
.
NO
∆
∇
or
to
Ready