Sharp AR-M205 소프트웨어 설정 매뉴얼 - 페이지 11
{카테고리_이름} Sharp AR-M205에 대한 소프트웨어 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M205 20 페이지. Digital multifunctional system
Sharp AR-M205에 대해서도 마찬가지입니다: 온라인 매뉴얼 (33 페이지)
10
Select the printer port and click the
"Next" button.
Select "LPT1" for the printer port.
If "LPT1" does not appear, another printer or
Note
peripheral device is using LPT1. In this case
continue the installation, and after the
installation is finished, change the port setting
so that the machine can use LPT1. This
procedure is explained in "Another printer is
using the parallel port (when using a parallel
cable)" on page 16.
11
When asked to select the printer
driver to install, select the appropriate
printer driver based on whether or not
the dual function board is installed,
and then click the "Next" button.
If the dual function board is not installed, be
sure to select "For standard model".
If the dual function board is not installed and
Caution
you select the printer driver for the dual
function board, printing will not be possible.
12
When the model selection window
appears, select model name of your
machine and click the "Next" button.
For the name of the model that you are using,
see "DIFFERENCES BETWEEN MODELS" in
the Operation Manual.
13
Click the "Yes" button.
INSTALLING THE SOFTWARE
14
When "The MFP driver installation is
complete." appears, click the "OK"
button.
The Sharpdesk installer will start.
15
Begin the installation of Sharpdesk (if
"Sharpdesk" was selected in Step 5).
Follow the on-screen instructions.
If the following screen appears, click the
Caution
"Skip" button or the "Continue" button as
appropriate to continue the Sharpdesk
installation.
If "Skip" is selected, the Sharpdesk
installation will continue without installing
Sharpdesk Imaging.
If "Continue" is selected, Sharpdesk Imaging
will be installed. If Imaging for Windows is
installed on your computer, Sharpdesk
Imaging will overwrite Imaging for Windows.
Click the "Finish" button when the message
informs you that setup is successful.
16
When the "Finish" screen appears,
click the "Close" button.
When "Now connect the MFP interface cable to
the PC." appears, click the "OK" button.
After the installation, a message prompting
Note
you to restart your computer may appear. In
this case, click the "Yes" button to restart your
computer.
17
Turn off the power of the machine and
your computer, and connect the
machine to your computer with the
parallel cable. (p. 10)
After connecting the machine to your computer,
turn on the power of the machine and then start
up your computer.
This completes the installation of the software.
• If you installed the MFP driver, configure the printer
driver settings as explained in "CONFIGURING THE
PRINTER DRIVER" (p. 11).
9