Sharp AR-M207 운영 매뉴얼 - 페이지 26

{카테고리_이름} Sharp AR-M207에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M207 35 페이지. Digital multifunctional system
Sharp AR-M207에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (44 페이지), 사용자 설명서 (3 페이지), 사양 (8 페이지)

BUTTON MANAGER SETTINGS
If you need to configure Button Manager settings, follow the steps below. For details on Button Manager settings,
see Button Manager Help.
1
Right-click the Button Manager icon
(
) on the task bar and select
[Settings] from the pop-up menu.
The Button Manager settings will open.
If the Button Manager icon does not appear
Note
on the task bar, click the [start] button,
select [All Programs] ([Programs] in other
than Windows XP), select [Sharp Button
Manager G], and then click [Button
Manager] to start Button Manager. The
Button Manager icon appears on the task
bar.
2
Click the tab that you wish to
configure.
3
Set up the start-up application in the
"Application Selection" area.
• If the [Show TWAIN setting screen when
Note
scanning] checkbox is selected, the
setting screen will appear when scanning
is executed to let you adjust the scanning
conditions.
• If an application other than [FAX] is
selected, you can select the "File format"
of the scanned image. If [PDF] is selected
for the file format, the image quality may
be slightly degraded.
(page 24)
4
Select scanning conditions such as
"Color Mode" and "Scanning Side" in
the "Scan Setup" area.
• If you placed a two-sided original in the RSPF,
select [Duplex-Book] or [Duplex-Tablet] as
appropriate for the position of the binding on
the original.
• The name of the tab can be changed. Click the
[Menu Name] button and enter a new name.
After entering a name, click the [Apply] button
or [OK] button. This also changes the scan
destination name that appears on the machine.
(Example: SC1: XXXXX)
• If you selected [Duplex-Book] or
Note
[Duplex-Tablet] from the "Scanning Side"
menu, select "Right Edge Fed First" or
"Leading Edge Fed First" for the
orientation of the original.
• For original sizes for which two-sided
scanning is possible, see "REVERSING
SINGLE PASS FEEDER / SINGLE PASS
FEEDER" in "3. PERIPHERAL DEVICES
AND SUPPLIES" in the "Operation
manual (for general information and
copier)".
• Some settings cannot be selected in
some applications.
• When [Show TWAIN settings when
scanning] is selected, only [Menu name]
can be selected.
5
Click the [OK] button.
This completes the settings.
SCAN
3
25