Sharp AR-M208 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Sharp AR-M208에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M208 32 페이지. Digital laser copier/ printer
Sharp AR-M208에 대해서도 마찬가지입니다: 주요 운영자 매뉴얼 (24 페이지)
[6] EXTERNAL VIEW AND INTERNAL STRUCTURE
1. External view
1
9
8
7
6
5
No.
Name
1
RSPF
2
Paper output tray
3
Front cover
4
Paper trays
5
Dehumidification heater switch
6
Power switch
7
Handles
8
Operation panel
9
Original table
10
Upper exit area cover
11
Side cover
12
Side cover handle
13
Bypass tray guides
14
Bypass tray
15
Bypass tray extension
Dehumidification heater switch (DH POWER)
This copier is equipped with a dehumidification heater, which prevents
dew condensation inside the copier and moisture absorption of paper
in the paper trays. If dew condensation occurs and causes moisture
absorption of paper, image quality may be deteriorated and paper mis-
feeds may occur frequently. It is recommended that the dehumidifica-
tion heater switch be left in the "ON" position in the following cases
even after the power switch is turned off.
• In a low temperature season such as winter (When a sudden tem-
perature change occurs, for example, immediately after room heat-
ing is turned on, dew condensation may occur.)
• In a high temperature and high humidity season such as summer or
rainy season (Depends on the use conditions. The reference is 60%
(humidity) or more.)
4
Duplex documents are automatically reversed to perform continuous copying of the front and the
back.
Finished copies are deposited in the paper output tray.
Open to remove misfeeds and for copier servicing.
Each tray holds 500 sheets of copy paper.
Press to turn on the heater to prevent dew condensation inside the copier and moisture absorption
of paper.
Press to turn copier power on and off.
Use to move the copier.
All copier controls are located here for easy operation.
Place the document to be copied here.
Open to remove misfeeds when an optional job separator tray kit or finisher is installed.
Open to remove misfeeds.
Lift and pull to open the side cover.
Adjust to the width of the copy paper.
Special papers (including transparency film) and copy paper can be fed from the bypass tray.
Pull out when feeding large paper such as 8-1/2" x 14" and 11" x 17".
AR-M208 EXTERNAL VIEW AND INTERNAL STRUCTURE 6 - 1
2
3
Function/Operation
• In regions at a high temperature and a high humidity
On
NOTES:
• When using the dehumidification heater, do not remove the power
cord from the outlet. Doing so will stop the heater.
• If an optional 500-sheet paper feed unit or 2x500-sheet paper feed
unit is installed, the heater in the unit will also be turned on when the
dehumidification heater switch of the copier is turned on.
10
11
12
13
14
15