Sharp AR-M276 주요 운영자 매뉴얼 - 페이지 18
{카테고리_이름} Sharp AR-M276에 대한 주요 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M276 24 페이지. Digital multifunctional system
Sharp AR-M276에 대해서도 마찬가지입니다: 소프트웨어 설정 매뉴얼 (18 페이지), 소프트웨어 설정 매뉴얼 (20 페이지), 사양 (9 페이지)
페이지 인쇄
PROGRAMS FOR PRINT MODE
This chapter explains key operator programs that are used for the printer function. These programs can only be
configured on models that have the printer function.
PRINT SETTINGS
KEY OPERATOR PROGRAMS
PRINT SETTINGS
DEFAULT SETTINGS
NETWORK SETTINGS
DEFAULT SETTINGS
These programs allow you to change certain default
settings for the printer function.
The "DEFAULT SETTINGS" consist of the following
programs:
● PROHIBIT NOTICE PAGE PRINTING
● PRINT DENSITY LEVEL
● PROHIBIT TEST PAGE PRINTING
● ROTATED PRINT
● FORCED OUTPUT OF PRINT
● EXCLUDE BYPASS-TRAY FROM ATS
● DISABLE DEFAULT SETTING CHANGES
PROHIBIT NOTICE PAGE PRINTING
This program is used to prohibit the printing of notice
pages. For an explanation of notice pages, see "If a
Notice Page is printed" in the online manual for printer.
PRINT DENSITY LEVEL
The print density can be set to one of five different
levels. [1] is the lightest level and [5] is the darkest
level.
PROHIBIT TEST PAGE PRINTING
(When the PRINTER EXPANSION KIT is installed)
This program is used to prohibit the printing of test
pages.
When the program is enabled, a test page cannot be
printed from the user settings. (See the operation
manual for copier)
ROTATED PRINT
This program is used to enable or disable rotation of
the print image when an A4R, B5R, or 8-1/2" x 11"R
(Letter R) document is being printed but there is no
paper loaded in that orientation.
16
OK
INTERFACE SETTINGS
INITIALISE AND/OR STORE
SETTINGS
FORCED OUTPUT OF PRINT
This program is used to enable or disable automatic
printing on a different size of paper when no paper
trays have the selected size of paper.
EXCLUDE BYPASS-TRAY FROM ATS
This program is used to exclude paper in the bypass
tray when automatic paper selection is used.
DISABLE DEFAULT SETTING
CHANGES
(When the PRINTER EXPANSION KIT is installed)
This program is used to prevent the configuration
setting defaults from being changed.