Sharp AR-M350 Imager 운영 매뉴얼 - 페이지 12

{카테고리_이름} Sharp AR-M350 Imager에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M350 Imager 40 페이지. Ar-m280 | ar-m350 | ar-m450 operation manual (for network scanning)
Sharp AR-M350 Imager에 대해서도 마찬가지입니다: 브로셔 및 사양 (11 페이지), 부품 설명서 (30 페이지), 운영 매뉴얼 (32 페이지), 리필 매뉴얼 (8 페이지)

페이지 인쇄

NORMAL COPYING

Select the desired output mode (see below).

2-SIDED COPY

OUTPUT

Use the numeric keys to set the desired number

of copies.

Press the [START] key.

NOTE

The 1-sided to 1-sided copying mode is set as the default

in the initial settings. This setting can be changed by a key

operator program (initial status setting ).

Output modes (sort mode and group mode)

[Example] Five sets of copies from three originals

● Sort copy

Originals

● Group copy

Originals

The sort mode is the default

mode. To select the group

mode, touch the [OUTPUT]

key,

then

touch

the

[GROUP] key on the output

setting screen, and then

touch the [OK] key on the

setting screen.

Up to 999 can be set.

Use the [C] (clear) key to

cancel an entry if a mistake

has been made.

If the [C] key is pressed

while originals are being

scanned, scanning will stop.

If copying had already

started,

copying

and

scanning will stop after the

original in progress is output

to the original exit area. In

these cases the copy

quantity will be reset to "0".

If scanning has been

completed but copying is

still in progress, copying will

continue.

Five sets of copies

Five copies of each original

When originals are placed in the document feeder tray,

a sort icon will appear on the touch panel and the sort

copy mode will be automatically selected. In this case,

copies will be delivered as shown in the upper illustration

to the left. For output in the group mode as shown in the

lower left illustration, the group mode must be selected

on the output setting screen.