Sharp AR-M620N 주요 운영자 매뉴얼 - 페이지 17

{카테고리_이름} Sharp AR-M620N에 대한 주요 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M620N 20 페이지. Digital multifunctional system

PROGRAMS FOR COPY MODE

Initial tab copy setting

This program is used to set the initial image shift width

(tab width) for tab copying.

The width can be set from 0 mm to 20 mm (0" to 5/8")

in increments of 1 mm (1/8").

Tab width

This program is used to set the maximum number of

copies that are allowed per original.

Any number from 1 to 999 can be set for the maximum.

The maximum number of copies is initially set to 999.

This program is used to prohibit the deletion and

changing of copy settings stored in job programs.

This program is used to disable the use of the bypass

tray when making duplex copies.

The bypass tray is often used to feed label sheets,

transparency film, and other special papers for which

two-sided copying is prohibited. If one of these special

papers enters the reversing unit, a misfeed or damage

to the unit may result. If special papers for which

two-sided copying is prohibited are often used, it is

recommended that you enable this program to prevent

feeding of special papers from the bypass tray into the

reversing unit during two-sided copying.

This program is used to disable the auto paper

selection function.

When this program is enabled, paper that is the same

size as the original placed on the document glass or in

the automatic document feeder is not automatically

selected.