Sharp AR-NB3 인쇄 매뉴얼 - 페이지 5
{카테고리_이름} Sharp AR-NB3에 대한 인쇄 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-NB3 41 페이지. Digital copier/printer/multifunctional system option
Sharp AR-NB3에 대해서도 마찬가지입니다: 네트워크 스캐너 운영 (40 페이지), 옵션 매뉴얼 (44 페이지)
페이지 인쇄
PRINTING FROM WINDOWS
5
Click the [Print] button ([OK] button in
Windows 95/98/Me/NT 4.0).
Printing begins.
The print job is delivered to the output tray, with
the position of the paper offset slightly from the
previous job (offset function).
IF THE TRAY RUNS OUT OF PAPER DURING PRINTING
Add paper to the tray that ran out or to the bypass tray. If you add paper to the bypass tray, press the [PRINT] key on
the machine to switch to printer mode and select "BYPASS-TRAY". Printing will resume. Note that if the "AUTO
TRAY SWITCHING" setting is selected in the "PAPER SIZE SET" (accessed by pressing the [SPECIAL
FUNCTION] key) and there is the same size of paper in another tray, the machine will automatically switch to the
other tray and continue printing.
PAUSING A PRINT JOB
To pause a print job, press the [PRINT] key on the machine to switch to printer mode and then select "OFFLINE"
with the [
] key. The machine pauses the print job and then goes offline.
• To cancel a print job, press the [C] key (
• To resume printing, select "ONLINE" with the [
WHEN "PAPER SOURCE" IS SET TO [AUTO SELECT]
If "Paper Source" is set to [Auto Select] in the [Paper] tab of the printer driver setup screen and the correct size of
paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "FORCED
OUTPUT OF PRINT" setting
When "FORCED OUTPUT OF PRINT" is disabled
Add paper to the bypass tray, press the [PRINT] key on the machine to switch to printer mode, and select
"BYPASS-TRAY". Printing will resume.
When "FORCED OUTPUT OF PRINT" is enabled
The closest size of paper in a tray other than the bypass tray will be used for printing.
If the print image is in a different orientation than the paper, the print image will be automatically rotated 90
Note
degrees to enable correct printing on the paper. (Other than the bypass tray)
HOW [BYPASS TRAY] AND [BYPASS MANUAL]
DIFFER IN THE "PAPER SOURCE" SETTINGS
There are two bypass tray settings in "Paper Source" in the [Paper] tab of the printer driver setup screen:
• When [Bypass Tray] is selected, the print job is automatically printed on the paper in the bypass tray.
• When [Bypass Manual] is selected, the print job is not printed until paper is inserted into the bypass tray. If paper
is already in the bypass tray, remove the paper and then re-insert it to begin printing.
4
).
] key.
(page 31)
in the key operator programs.
When the job separator tray is
Note
installed
The output tray can be selected when
selecting print settings at the time of
printing. To change the tray selection, select
the desired tray in "Output" in the [Paper]
tab of the printer driver setup screen.