Sharp Gemini II Plus MX-2614N 테크니컬 핸디 매뉴얼 - 페이지 13

{카테고리_이름} Sharp Gemini II Plus MX-2614N에 대한 테크니컬 핸디 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Gemini II Plus MX-2614N 42 페이지.

Automatic Colour Calibration

When adjusting colour balance before or after routine maintenance, always use the

Note

recommended paper (Mondi 90gsm or equivalent) for optimum image quality.

1. Always ensure the latest firmware is installed on the copier, this can be visually checked using

SIM22-05 or printing the data sheet using SIM22-06.

2. Check that A/E settings and manual colour calibration settings are set to default (page 2 of SIM22-

06 data sheet)

3. Ensure all maintenance work is carried out, checking maintenance counters in SIM22

4. Ensure optics cavity is clean, clean main charge unit using special tool and clean laser slit glass

5. Perform colour image density sensor adjustment in SIM44-13 using special tool (UKOG-0318FCZZ)

refer to ADJ 3 in service manual

6. Next perform black image density sensor adjustment in SIM44-02, refer to ADJ 3B in service

manual

7. Perform image skew adjustment and registration adjustment using SIM50-22. When performing

skew adjustment follow procedure in ADJ 5 in service manual

8. Execute SIM44-27, halftone process control correction data clear

9. Execute SIM44-06, Process control correction (force)

10. Execute SIM44-26, halftone process control correction execution

11. Perform colour balance adjustment SIM46-74, place printed pattern on to glass for both engine

and printer modes

Engine Calibration Pattern

Colour Calibration

FACTORY MODE

Printer Calibration Pattern

Document Solutions After Sales Service