Sharp Gemini II Plus MX-2614N 테크니컬 핸디 매뉴얼 - 페이지 18
{카테고리_이름} Sharp Gemini II Plus MX-2614N에 대한 테크니컬 핸디 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Gemini II Plus MX-2614N 42 페이지.
페이지 인쇄
All MX series machines have a coin vend interface located on the PCU Main PWB. The vending device activates
various signals to indicate paper sizes and operation.
Because of additional functionality, the interface connector has been changed from 12 to 16 pins.
Before connecting a third party auditor, the device should confirm to the following:-
1. The auditor interface should be optically isolated from the copier.
2. The device should be Power Supply Unit independent.
3. The device power supply unit should be a plug top adapter, not internal.
4. The plug top adapter should have a reinforced insulation barrier.
5. The audit device MUST hold a CE Mark.
To enable coin vend function, test simulation 26 –03 should be set as required:-
The specified quantity
is completed.
Diagnostic
Remainder of money
Setting
MODE 1
MODE 2
MODE 3
OPERATION 1 Wait for auto clear setting time
OPERATION 2 Auto clear is not made.
OPERATION 3 Setting is immediately cleared.
Coin Vend Interface
Connector Manufacture:
Connector Type
Connector Part Code (Wire Side)
is left
Condition 1
Operation 1
Operation 1
Operation 1
(Default 60sec – can be changed by the system setting)
Insufficient money during copy job
Black/Colour
(No money
(Remainder of money
remaining)
Condition 2
Operation 2
Operation 1
Operation 3
18
CABCOM
Interface Cable
L80INVENDKIT5
The specified
Colour
left)
Condition 3
Operation 2
Operation 2
Operation 2
Document Solutions After Sales Service
quantity is
completed.
No money
remaining
Condition 4
Operation 1
Operation 1
Operation 3
Cont.