Sharp MX-2300N Guide 문제 해결 매뉴얼 - 페이지 5
{카테고리_이름} Sharp MX-2300N Guide에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp MX-2300N Guide 44 페이지. Sharp mx-2700n, mx-2300n mfp - scan to e-mail instructions
Sharp MX-2300N Guide에 대해서도 마찬가지입니다: 사양 (2 페이지), 안전 매뉴얼 (28 페이지), 문서 제출 매뉴얼 (47 페이지), 스캔하여 이메일 지침 (7 페이지), 소프트웨어 설정 매뉴얼 (48 페이지)
페이지 인쇄
REMOVING MISFEEDS
This chapter explains what to do when a paper misfeed occurs in the machine.
Removing misfeeds
When a paper misfeed occurs, "A misfeed has occurred." appears in the touch panel and printing stops. In this event,
touch the [Information] key in the touch panel. When the key is touched, instructions for removing the misfeed will
appear. Follow the instructions. (The approximate locations of possible misfeeds are indicated by blinking
shown below.)
Caution
The fusing unit is hot. Take care not to burn yourself when removing a misfeed.
• When removing misfed paper, do not touch or damage the transfer belt.
• Carefully pull the paper out without tearing it.
• A misfeed may have occurred inside the machine. Check carefully and remove the misfeed.
• If the paper tears, be sure to remove all pieces from the machine.
Paper misfeed illustrations
If you require more information when reading the instructions in the touch panel, see the paper misfeed illustrations on
the following pages. Refer to the illustration below and then go to the appropriate illustration (1 to 14) for your situation.
☞
(1)-(4): page 4, (5)-(10): page 5, (11)-(14): page 6
(11)
(14)
A misfeed has occurred.
Full Color
Turning M/C off now causes data loss.
Color Mode
Job Detail
Settings
Auto
Exposure
Information
100%
Copy Ratio
(12)
(13)
Misfeed location
2-Sided Copy
Output
Special Modes
File
Quick File
(1)
(2)
(3)
(8)
(9)
0
Fusing
area
(10)
(4)
(5)
(6)
(7)
marks as
3