Sharp MX-M453 소프트웨어 설정 매뉴얼 - 페이지 28

{카테고리_이름} Sharp MX-M453에 대한 소프트웨어 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp MX-M453 48 페이지. Digital multifunctional system
Sharp MX-M453에 대해서도 마찬가지입니다: 안전 매뉴얼 (32 페이지), 브로셔 및 사양 (12 페이지)

페이지 인쇄
Sharp MX-M453 소프트웨어 설정 매뉴얼

INSTALLING THE SCANNER DRIVER

The scanner driver (TWAIN driver) can only be used when the machine is connected to a network. When the scanner
driver is installed, PC scan mode of the image send function can be used.
Supported operating systems: Windows 98/Me/2000
* Administrator's rights are required to install the software.
After performing step 1 through step 5 of "OPENING THE SOFTWARE SELECTION SCREEN (FOR ALL
SOFTWARE)" (page 8), continue the steps below.
1
Click the [Scanner Driver (TWAIN)]
button.
2
Follow the on-screen instructions.
Read the message in the window that appears and click
the [Next] button.
3
When the finish setup window appears,
click the [OK] button.
4
Click the [Close] button in the window
of step 1.
After the installation, a message prompting you to
restart your computer may appear. If this message
appears, click the [Yes] button to restart your
computer.
26
*
*
*
/XP
/Server 2003
/Vista
This completes the installation. Next, configure the
IP address of the machine in the scanner driver.
When the scanner driver is installed, the "Select Device"
utility is also installed.
The IP address of the machine is configured in the
scanner driver using "Select Device".
5
Click the [start] button, select [All
Programs] ([Programs] in Windows
98/Me/2000), select [SHARP MFP
TWAIN K], and then select [Select
Device].
6
Click the [Search] button.
If you know the IP address, you can click the [Input] key
and enter the IP address without searching.
*
*
/Server 2008